Die Cutting Machine (Die Cutting Machine), also known as beer machine and numerical control punching machine, is mainly used for die cutting (full break, half break), indentation and bronzing operations, bonding, and automatic waste discharge of corresponding non-metallic materials, self-adhesive adhesive, EVA, Double-sided tape, electronic, mobile phone rubber pads, etc. The die cutting machine uses steel knives, hardware molds, steel wires (or stencils carved from steel plates) to exert certain pressure through the imprint plate, Roll and cut printed matter or cardboard into a certain shape. It is an important equipment for post-press packaging processing and forming.
The working principle of the film cutting machine:
The working principle of a die-cutting machine is to use steel knives, hardware molds, steel wire (or steel plate carved templates), and apply a certain amount of pressure through the impression plate to cut the printed product or cardboard into a certain shape. If the entire printed product is pressed and cut into a single graphic product, it is called die cutting; If steel wire is used to press marks or leave bent grooves on the printed product, it is called indentation; If two templates of yin and yang are used, and the mold is heated to a certain temperature, a three-dimensional pattern or font is printed on the surface of the printed product by hot stamping, which is called hot stamping; If one substrate is applied to another substrate, it is called lamination; Excluding parts other than genuine ones is called waste disposal; The above can be collectively referred to as die cutting technology.
Die cutting machine process:
The die-cutting process is the most commonly used process for packaging printed products, which is to use a die-cutting knife to assemble a die-cutting plate according to the design requirements of the product. Under the action of pressure, the printed product or other circular packaging blanks are rolled and cut into the desired shape or cut marks. The indentation process is to use a wire cutter or die to press lines on the sheet metal through pressure, or to use a rolling wheel to bend and shape the sheet according to a predetermined position. Usually, the die-cutting and indentation process is the process of combining the die-cutting knife and the indentation knife into the same template, and simultaneously performing die-cutting and indentation processing on the die-cutting machine, abbreviated as die-cutting. The main process of die-cutting indentation is as follows: plate loading → adjusting pressure → determining rules → pasting substrate and auxiliary materials → pressure testing die-cutting → formal die-cutting indentation → waste cleaning → finished product rolling or cutting into pieces → counting and packaging.
Applicable scope of die-cutting machine:
1. Adhesive products: for all kinds of electronics: special electrical adhesive pads, silica gel stickers, velcro stickers, conductive adhesive, strong Double-sided tape, 3M, Sony special adhesive stickers, backlight screens, and other adhesive products used in the electronics industry, IT industry, membrane switches, and automobile manufacturing industry.
2. Dust proof materials: Cotton pad, camera cotton, high-density sponge, filter cotton, dust-proof net, non-woven fabric.
3. Shockproof products: rebound rubber pad, rubber, transparent foot pad, PORON pad, 3M, flame retardant EVA, high foam.
4. Insulation EMI: Fired express paper, aluminum foil, copper foil, PVC, PET, Kraft paper, sponge sheath, pearl sheath.
5. Heat resistant and insulation materials: silicone sheet, transparent mica sheet, fiber cloth, insulation cotton (cloth).