1. When starting up, only one person can operate it. When the machine starts, there will be an alarm, and all personnel should be in a safe position at this time.
2. Before pushing the upper and lower plates into the machine, it is necessary to check for any foreign objects and ensure that the plate screws are tightened. Push the board gently to avoid damaging the machine.
3. When pulling up and down, the pulley and locking pin must be in place to prevent falling and injuring personnel.
4. When adjusting the side and back alignment, simply push the paper. Do not allow too much thrust to avoid damaging the components.
5. When stopping for a long time, it is necessary to pull the upper and lower plates out of the machine and park the lower platform at the lowest position.
6. Run the machine for 3 to 5 minutes before normal startup, and check whether the oil pressure and air pressure are normal.
7. Before inserting the turning gear handle, be sure to wait until the flywheel stops rolling completely. When manually turning, the turning staff should stand on the side of the turning handle. The turning direction should be reverse.
8. When raising the paper receiving table, it is important to concentrate your thoughts highly to prevent the paper stack on the paper stool or paper stool from colliding with the paper leveler and damaging other components, such as the teeth. When raising the paper feeding table, it is necessary to prevent the paper stack stool from exceeding the limit and hitting the Feida head.
9. When lowering the paper feeding and receiving tables, prevent feet from being crushed.
10. When extracting samples, pay attention to your gestures to prevent your hands from being raised too high and being injured by your teeth.
11. When hot stamping with the flat press die-cutting machine, it is important to note that when the first (last) sheet is hot stamped, the machine pauses the alarm and begins to self increase (decrease) the pressure. After increasing (decreasing) the pressure, it will continue to operate. During the pause, the operator should pay attention to safety.
12. When the paper receiving rack is not stopped, be careful not to take too long. As the paper receiving rack does not automatically lower without stopping, excessive paper thickness can cause the machine to automatically stop or damage the machine.
13. When entering the machine for operation, it is necessary to first stop the lower flat motor at the lowest position and stop the main motor. Only after the flywheel is completely stationary can inspection or installation of aluminum carbide be carried out, otherwise it is not safe.